Joined: Oct 02, 2014 Posts: 1999 Location: South Carolina, Dorchester County
Posted: Thu Jul 01, 2021 11:25 am Post subject:
Hi Cowboy,
Using the drain plug at the bottom of the cannister is nothing but asking for a mess. I avoid it.
After I lift the old filter out of the cannister (messy enough), I use a hand siphon pump (available at most auto parts stores for less than $10) to remove the rest of the oil from the cannister. Then wipe any crud out of the bottom with lint-free rag. You could also do it with a small cup or turkey baster.
Then I inspect the pin-hole in the upright tube to make sure it's clear. I then put about a pint of fresh oil in the cannister and slowly insert the new filter. You have to experiment with how much oil to put in because too much and inserting the new filter will cause overflow and another mess. As the new filter submerges it'll soak up oil. I only do this to help get the oil flow on start-up back to normal faster. Not sure it's really necessary but makes me feel good anyway. You could skip this and just put 4-5 quarts into the crankcase and the cannister will fill up fast after you start the motor anyway. Run it up to operating temp while checking for good oil pressure and leaks, shut it down, then check/fill to full on the dipstick.
Use a new (and properly oiled) gasket on the lid and a new copper washer on the bolt. Not tight enough and you'll have a good leak and another mess.
That's what I do anyway. Good luck! _________________ Ron D.
1951 M38 Unknown Serial Number
1951 M100 Dunbar Kapple 01169903 dod 5-51
“The only good sports car that America ever made was the Jeep."
--- Enzo Ferrari
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum