Joined: Nov 24, 2010 Posts: 1390 Location: Orem, UT
Posted: Fri Apr 15, 2011 5:09 pm Post subject: Tcase front output shaft play
Upon re-assembling my D18, I noticed that the front output shaft has about 1/8" in and out play to it. Is this normal? I didn't notice it before but then I wasn't looking for it. There is no side to side play and bearing is snug with the snap ring in place. My thinking now is when I go and put on the yoke, it should keep it up against the bearing.
I believe that is a non-issue. As you said when the yokes go on the play will go away. Note there aren't any axial play limits published anywhere for it. It is important though to have the front output cover installed before you set the clearance on the rear output bearing since the front end bearing of the rear output sets up against the front cover. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
