Search found 3475 matches

Sometimes one has to quietly ease away and call it a win, or at best a tie.

It works that way with hand grenades and wives..

Your M38 came with the YS637 and that’s what is in it now?

Sounds like your metering rod is too short.
Should be the lower one in Wes’ post?

Many of them are.
My 1950 M38 has an earlier rear differential.

They are nowhere aerodynamic. Exhaust fumes probably being pulled forward from the rear while moving down the road.

You’ve seen the fancy fairings on the rear of big rig trailers? They are designe ...

Hi Ryan,
Did I mention to you the Machinist website I’m on?

Chaski?

http://www.chaski.org/homemachinist/

It’s a closed member list like this one, that public can see, but not post or contact ...

You can cut out a pattern for the beads from hardwood, and hand form with the sheet laying on top. Think about tracing a pattern with a sheet of paper on top, brushing lightly with a pencil.

Using ...

Unfortunately I think we lost Bretto a while ago. He had some really good restoration photos as well as measurements for parts he fabricated.

It would be a shame to lose the good stuff.

The synchros are somewhat out of focus but look pretty worn too, so you want to replace them anyway. Since it will be apart…

Even backing up the as-is site as a view only site for reference and moving to a different one for fluid data would be very helpful.

I can even begin to guess how many times I’ve searched subjects ...

Hi Ryan,
Can we throw money at the issue?

Worse than that. Water could seep in around the bottom of the seal while fording.

If you are fording in deep water the tub will have water in it anyway. That’s what the two drain covers are for on ...

Hi Ron,
Cleaning cosmoline off something does point to some authenticity.

Maybe it will turn out ok.

I’d really like to see a photo of that puppy in a factory crate, Bro.

eBay is a great place to find OEM parts, many in their original packaging.

Brass inlet connection, 7/51:

https://www.ebay.com/itm/364198205640

You could Chuck them up and cut them off in the lathe.

Heck, make a few more and sell them. You have the magnets…


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.