Search found 97 matches

If you still have the underwater fording set up, note that the vacuum pump return line goes into the intake. I get oil past the diaphragm seal and it intermittently gets sucked into the intake. Stin ...

I'm going to bite the bullet and get a new oil pump. The bearings are trashed on the crank. Will take it to be machined. The bearings were .020 over. I will learn from my mistakes as it is an oppo ...

I pulled the rod bearings and that was it. The rear one had metal in it. Small pieces in the oil pan too. I was able to turn the engine with a socket one I removed the rear cap and bumped it back a ...

Background on the engine. It was rebuilt a a machine shop approximately 12 years ago for the PO. I have ran it 1365 mile with out issue. It has always had low oil pressure but I am running a 70 yea ...

Sent reply and my phone number. Thanks for your interest.

1951 Willys M38 Jeep tub $750. Pretty good shape. It's an extra I did not use on my restoration project. Previous owner replaced the hat channels underneath. There is no toolbox but I have a CJ 2A too ...

Wes, I found it elsewhere on the inter-web from a couple locations.

Thanks Ron.

12.25" more or less is the answer. Mine is right on the money.

Could someone measure the width of the box and report back? I have a 11/1952 Stick and one of the brackets appears bent from perpendicular and want to know how far off from the box it would be if I r ...

The oil pump could be off a tooth. My personal experience was when my engine was rebuilt and reassembled the pump was installed 180 degrees off. It had never ran. I finally figured that out when pu ...

I would be happy to donate to upgrade to something more secure and user friendly.

I rebuilt the stock carb on my M38 with an Ebay kit. Note that I contacted the vendor because one diaphragm was assembled backwards (overseas junk). They sent a new kit. It was a bit doggy off idle ...

Sounds like your driveshaft u-joint. I have had them go south on other vehicles and they sound like very angry birds.

I know there is threads on this site that describe length and gauge but the specifics escape me at the moment. I went with those numbers to the local welding shop who made a set for me.

There is a guy on eBay right now with $25 Spartan horns. Good luck.


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.