Search found 184 matches

T90 rebuild. There is a large spacer between the bearing retainer and the throw out bearing carrier.
Have not seen this before. Could not find this spacer in diagrams. Seems it would change the c ...

I found rust on some gear teeth mating surfaces on my T-90. Do these need to be replaced and why?

http://willysmjeeps.com/v2/modules/gallery/albums/album726/IMG_4275_001.sized.jpg

http://willysm ...

Went to starter rebuilder. Showed him the following video. The video shows 2 voltmeters. Left is battery voltage, right is voltage at starter. Voltage is the same while cranking, but drops to 12 volts ...

Starter out. Appreciate your help!

Thanks Wes!
I have been known to overthink.
Appreciate your patience and guidance, as always.

Do I need to remove the starter switch from the top of the starter?
The pivot arm from foot starter to the switch is also in the way.
Sorry to be such a needy dummy on this one. For some reason a l ...

How do you remove the top starter bolt? None of my tools can reach that “blind bolt”. It’s a 52 M38 with late model (M38A1 style) 24 volt original Auto Lite starter.

Thanks Wes.

Re-checked timing. I have the raised bump on the cover and hole on inside of pulley. It’s awkward to get a clear view at the correct angle, but it looks like 10 degrees BTDC.

Will pu ...

Bringing back my old thread.
Let me know if you prefer I start a new one.

Please listen to this video clip of my laboring, slow turning starter.

https://drive.google.com/file/d/1wgTT-mPXgf0-Yp ...

Just a clarification Wes.
It will “accept” the military copper compression fittings sold by MWM?
Or, yes to all “except” the fittings?
If it does not accept the original military fittings and tubin ...

Well don't I feel stupid. It's been so long since I've driven the M38, that I completely forgot about the hand pump on the fuel/vacuum pump. Scoutpilot rebuilt it so it should work.

RonD2's sugge ...

I’ll admit the M38 and A1 carbs are somewhat confusing to me. I’m used to a conventional mechanical accelerator pump that gives you a squirt of gas before starting,
Because of this, I’ve considered a ...

Thanks RonD2 You've been a big help over the years. Much appreciated. Been on the sidelines and M38 sat for an extended period.

Answers to your good questions:
Original 24v ignition system, car ...

Been on the sidelines with health issues. M38 has been sitting for 3.5 months.

My usual start procedure (per Scoutpilot from carb and fuel pump rebuild): Full choke until engine kicks once. Then ...

Ohm readings for sender 1200923-2
1.8 ohms empty (float down)
24.4 ohms 1/2 full
40.5 ohms full (float up)

Ohm readings for sender 11640674
3.4 ohms empty (float down)
16.1 ohms 1/2 full
32 ...


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.