Search found 409 matches

It’s called an email flame/ flaming.
Flames produce absolutely no joy.
Flames are harmful to the mission.
Flames can be resolved.

* Shift the discussion to PM & phone.
* Find common ground. ...

Hi. My 2 cents.

Started out wanting mostly original take off or NOS parts for my project. Using the ‘real stuff’ is so very cool but there are a few areas where a good repo is often the wise choic ...

Thanks Wes

Sounds like I have the wrong cable or a stretched out cable.
Per Rg’s suggestion I will call around for the shorter cable.

Maybe I am getting my jeeps mixed up.

My jeep’s engine stay cable came with two nuts. Can’t remember if the cable was part of the stash or mounted on the jeep. The bell & plate were replaced w ...

Went to install the two bell housing brackets shown above... but now another little problem.

My engine stay cable measures 15 1/2” which is a good 1” too long.
Leaving off the aft nut would make ...

http://willysmjeeps.com/v2/modules/gallery/albums/album701/068_G_002.sized.jpg

Went to install the engine stay cable and noticed I had left off the two bell housing support brackets. These brackets were not on the jeep or in the stash when I got it. The bell, plate and starter a ...

“Lets just say with a stroke of bad luck this morning...” April.

You deal well with adversity. Bravo.
At times my project has given me a case of the ‘bad attitude’ which is counter productive. ...

“The crimp tool is used for Douglas and Packard style connectors.” Ron
Yes. My crimp tool is for the connectors.

The thing about my VR to generator cable is the wires under the shielding mesh. Co ...

Hi Ron.
I ended up buying a rebuilt VBC-4002UT voltage regulator. Will need to do some ID homework on the two VR cables.

I have what looks to be the original VR to generator cable. The protective ...

Kendall‘s M38 harness chart is great.

Looks like the big challenge on the VR harness is finding a VR cannon plug with good pins and a few inches of good wire on each pin. I have read the threads on ...

Oops. In my earlier post I mentioned some harness pics in the Wes album.

http://willysmjeeps.com/v2/modules.php?set_albumName=album184&id=M38_Volt_Reg_Harnesses_sm&op=modload&name=galle ...

Thanks to all for the info.

Don

Hi Rick.
The tail light wires have multiple metal tags. None of the numbers match what should be there. The light cans have replacement guts which may explain the quirk. It’s like someone decided to ...

Slow progress. Lots of little setbacks. Zeno's Paradox.
Had some problems with the clutch pedal assembly that required trim job on a hat channel edge and adjustments to the linkage yokes.
Should be ...


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.