Search found 458 matches

Just to confirm, did you buy an awl or palm?
For refastening straps either will work. The repair depends upon your keeping significant tension on the thread.
For a rip in canvas, trying to sew a ri ...

I just dismantled my cable connection to see what I had installed. The frame hole A on my frame will accommodate a 1/4” bolt - no larger. I do not have hole “b” in the body mount bracket.

I did ...

Use of hole B referenced above may be a challenge due to the available cable length and lack of access and space for a nut between the body mount and hat channel.
If you would like a photo of my inst ...

The ground lead attaches to the frame. There is a pre-drilled hole about 1.5” to the rear of the bottom rivet of the body-mount bracket.

Where are you located?
What are you trying to have repaired?
Brian moved a few years back but the town escapes me at the moment.
If you are looking to have differential work done and you are in the ...

Thank you for all you gave Maj. Ben. From USMC to Community to us on MJeeps you are missed.

Being clear - there are only 2 manufacturers of reproduction tubs: MDJuan (Phillipines) & SGI (India).
Any vendors you see in the US sell one or the other. Do your research as there is plenty o ...

Were you able to balance your tires by using weights only on the inside of the rim?

You did not mention the clutch but I have to ask - did you change anything of the clutch?
Is the chatter all the time or only when letting your foot off the clutch?
For clarity is your “chattering” ...

The hood blocks on the M38 look special.

I used PC7 epoxy and mixed it with OD paint. After smoothing and wet sanding the match was close enough that the repairs are not overly apparent and the steering wheel is still its original finish ra ...

Were the letters white? Or natural unpainted alloy?
If Alloy (how I did mine) use a small very flat sanding block with 1500 grit sandpaper to remove the paint.
If you want white letters you can fir ...

Experiment with adding OD paint to your epoxy (I used PC7 epoxy - now 12 years ago). If you match the epoxy color to the wheel you can do a final sanding of the epoxy with fine paper. Then sand the e ...

Nice work on the family jeep! It's great to see these jeeps alive again with their family memories in the drivers seat. Have fun with it.

Looking to buy a late M38 version (after s/n 31xxx) steering gear box.

Can rebuild but should have a good worm and sector.

Thanks
Tom

27Aug19. Update - got one on the way. Thanks


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.