Search found 149 matches

thank you Ron and Wes.

I went through searches on bearing cross reference and went down a rabbit hole trying to hard to find other bearing references.

Ron, I drew a lightbulb moment afterward ...

Yes they are the same Timken numbers.

Front:
Cone 18590 2 at each wheel
cup 18520 2 at each wheel

Rear:
Cone 25877 1 at each wheel
Cup 25821 1 at each wheel

Seal National 13710 1 a ...

update:

Mike/Wes

took me longer to post this than the actual fabrication, but got it done. i wanted to say thanks for measurements and pics. I actually had to fabricate from scratch the front ...

IF you are looking for very good war movies lately, I highly recommend the forgotten battle, operation mincemeat, 1917, and dunkirk just to name a few.

MIke/Wes

thank you for that info and pic.

one last question if you don't mind....what would be the distance from the floor to the center of bend (before it goes to seat frame? Ball park. t ...

Thanks guys. I appreciate the measurement as I know at least where mine needs to be.

Wes, thank you. Hi was actually looking in your album and saw those pics and realized I am missing mine. An ...

Thanks guys. I appreciate the measurement as I know at least where mine needs to be.

Wes, thank you. Hi was actually looking in your album and saw those pics and realized I am missing mine. An ...

edit: the angle of the piece would also be appreciated as well. and if anyone has the ability to get me the measurement of the front right driver's side seat frame leg (from top of curve to floor). ...

HI Wes.

I would greatly appreciate any measurements if you can provide....and if you can tell me the thickness of the material that would be great too. tThank you.

if anyone has plans of it ...

Thanks Wes 2x.

I just figured out how to post pics in my album, so I was almost there!

thanks for the link to your album. I need to track one down!

Hi

i am wondering what is the purpose of the bracket welded to the underside floor of the M38 near the transmission hump on the hat channel

also was wondering if anyone has the dimensions for ...

Thanks ron. Really appreciate that.

One more quick question. What is length between bends?

Hi good discussion. I am looking for dimensions for the clamp strap that holds tank to the back floor on M38. Look for width and thickness of material

Well deserved. I cannot think of the number of times I have looked up something for my project only find that Wes or Ryan had answered it to the point. I am one who has been doing body and frame work ...

Yikes that is quite the piece of work. Wonder I can just bid for the rad. Loll


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.