View previous topic :: View next topic |
Author |
Message |
32sbct Member
Joined: May 09, 2011 Posts: 166
|
Posted: Mon Oct 15, 2012 11:45 am Post subject: Drag link question |
|
|
Below is a picture of my original drag link next to the new drag link I ordered. You'll notice that the original was a greater diameter and has two bends in the bar, about 6 inches from either end. I'm assuming that the new one is a functional replacement. My question is which end of the new one goes on the pitman arm and which end goes on the bell crank? I'm assuming the end with the bend goes on the bell crank and the straight end goes on the Pitman arm. Originality is not an issue. Your thoughts? Thanks.
|
|
Back to top |
|
|
32sbct Member
Joined: May 09, 2011 Posts: 166
|
Posted: Mon Oct 15, 2012 1:56 pm Post subject: |
|
|
Please disregard. I took a better look at the original. The end that has the greater distance between the hole and the end of the drag link goes to the pitman arm. |
|
Back to top |
|
|
oilleaker1 Member
Joined: May 14, 2009 Posts: 972 Location: South Dakota
|
Posted: Tue Oct 16, 2012 5:43 am Post subject: |
|
|
If it was me, I'd clean up the old one and put the new cups and guts in it. The repro looks way off. John |
|
Back to top |
|
|
wesk Site Administrator
Joined: Apr 04, 2005 Posts: 16355 Location: Wisconsin
|
|
Back to top |
|
|
32sbct Member
Joined: May 09, 2011 Posts: 166
|
Posted: Tue Oct 16, 2012 7:05 pm Post subject: |
|
|
Yes, I agree. I think I am going to clean up the old one and rebuild it. The length from hole to hole is basically the same but there is no doubt that they are different. I already have a rebuild kit so I'll spend some time this weekend and get it done. |
|
Back to top |
|
|
|