Joined: Jun 09, 2011 Posts: 776 Location: Bellmore, NY
Posted: Sat Nov 03, 2012 3:34 pm Post subject: Oil Sender gauge problems
The combo oil sender/oil gauge John from Midwest Military sent me is reading strange. It was reading real low, like 20 PSI at startup (I have a rebuilt engine, straight 30W in it) and down to like 15 or less at idle. If I revved the engine, the gauge didn't move. Now it is suddenly reading about 55 at start up, and only dropping minutely at idle. And, when I turn the key, without even starting the engine, it was jumping up to 20 PSI, sometimes 30.
If I hook up a manual gauge to the oil sender port, it reads fine _________________ 1952 M38A1
Marine core reinforced rear bumper, military transistorized turn signal upgrade, arctic heater, 11" drum brakes, 200L PTO winch, Huffy overdrive, deep water fording kit, RT 68 vehicle mounted radio, Trac Locs front and rear.
www.danhenk.com
In your position with the jeep as your only ride I would just plumb the direct gauge into the dash. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: Jun 09, 2011 Posts: 776 Location: Bellmore, NY
Posted: Sat Nov 03, 2012 10:21 pm Post subject:
Now, all of a sudden, the oil pressure gauge is reading differently. It reads 15PSI with the ignition on, but the engine off. It's about 55 at startup, and back down to 30 at idle. John from Midwest military sold me a first sender that didn't work at all. He sent me a second one I'm using now. I emailed him, and he said he was sure it was the sender. He'd credit me if I sent it back, but not replace it. _________________ 1952 M38A1
Marine core reinforced rear bumper, military transistorized turn signal upgrade, arctic heater, 11" drum brakes, 200L PTO winch, Huffy overdrive, deep water fording kit, RT 68 vehicle mounted radio, Trac Locs front and rear.
www.danhenk.com
Joined: Jun 09, 2011 Posts: 776 Location: Bellmore, NY
Posted: Sat Nov 03, 2012 11:17 pm Post subject:
Alright Wes, I used the method on your link, and it's definitely the gauge. It helped me to isolate the fuel gauge too. I thought it was the sender, but it looks like it was the gauge. _________________ 1952 M38A1
Marine core reinforced rear bumper, military transistorized turn signal upgrade, arctic heater, 11" drum brakes, 200L PTO winch, Huffy overdrive, deep water fording kit, RT 68 vehicle mounted radio, Trac Locs front and rear.
www.danhenk.com
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum