Joined: Mar 08, 2013 Posts: 20 Location: Edinburgh/Scotland
Posted: Sat Mar 09, 2013 1:58 am Post subject: TECHNICAL
my m38a1, has a temp gauge problem.
after a while driving it moves up to 260 on gauge ,
i have cleaned the fittings at rear and the engine temp switch twice its 24volt and cut back the douglas connector thinking its a break in wire but problem stil there.
there is no over heating
its just a pest when out driving, any ideas on what to do.
Joined: Mar 13, 2006 Posts: 1079 Location: Richburg, SC
Posted: Sat Mar 09, 2013 7:43 am Post subject:
M series gauges are notoriously unreliable. You can start with this troubleshooting guide from the downloads section http://willysmjeeps.com/downloads/instruments.pdf . There is a lot of info available in the downloads section. _________________ Matt
1953 M38a1
1964 USMC M38a1
'51 USMC M100 trailer, '54 M100 trailer, '90 M101a1 trailer
Http://wilfreeman.wordpress.com (M38a1 build blog)
http://m38a1usmc.wordpress.com (USMC M38a1 rebuild blog)
You should first troubleshoot the wiring, gauge and sender in accordance with the TB suggested above. If a component is not up to mustard the tests will reveal which component/s it/they are. Your symptom speaks strongly of a short in the wire between the gauge and the sender.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum