Joined: Oct 06, 2014 Posts: 252 Location: South Dakota - Aberdeen
Posted: Sun Jan 04, 2015 2:41 pm Post subject: steering tie rod end
Any suggestions on how to get this nut off the steering tie rod end bolt? The bolt turns with the nut. I have tried wd40 and heating it. Any tips would be welcome... PS I do have the cotter pin out!
Joined: Jun 17, 2012 Posts: 159 Location: Minnesota
Posted: Sun Jan 04, 2015 3:52 pm Post subject:
Are you going to re-use the tie rod end? If not, remove the cotter pin, then cut the nut top down, with a thin cut off blade. Don't go too far and cut into the arm tho.
Dan _________________ Dan Schultz
MD20035 9/1952
MC70324 dod 6/52
GPW 14944 dod 4/10/42
K38 Linemans Trailer 4/43
M100 Trailer 01177488 dod 8/51
Joined: Apr 11, 2005 Posts: 174 Location: Coventry, RI
Posted: Sun Jan 04, 2015 4:47 pm Post subject:
The bolt is actually a tapered shaft. I've had good luck putting a bottle jack underneath and applying pressure in addition to some heat and/or PB Blaster
Soak it really good with PB Blaster for a day or two. Wedge a pickle fork between the arm and the tie rod. Then use an impact wrench to turn the nut off.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum