Well that's good news. Who was the vendor on that invoice? Your Kit part number on your invoice is 804533K which is not even close to the three recall part numbers:
Quote:
Edited by Wes K :
Both 7/8' and 15/16" shafts are effected by the recall. This is directly from the recall announcement by Omix-Ada: " If you have replaced an Omix steering sector shaft, part numbers 18027.01 (7/8 shaft), 18027.03 (a repair kit with bushings and 7/8 shaft) and 18027.02 (15/16 shaft) identified in this campaign." so be careful and do not assume since you have a 15/16" shaft you are good to go!
It is odd that your 804533K kit came with all those Omix-Ada numbered parts bags:
18029.01 Bearings
18029.03 Bushing
18029.04 Seal
18029.07 Bushing
but without a number for the shaft itself. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
I got a reply from Carl at Walck's and he uses the Crown shaft in his 804533 kit and has for a few years. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: Oct 02, 2014 Posts: 2005 Location: South Carolina, Dorchester County
Posted: Wed Dec 30, 2020 11:42 am Post subject:
Hi Horse,
This post and your question is buried in the "M-Series Parts Supply and Service Review" part of the forum ---- where nobody is likely to see it.
I recommend that you post your question as a new topic in the "Technical Knowledge Base" forum. You'll get a lot more response.
Good luck! _________________ Ron D.
1951 M38 Unknown Serial Number
1951 M100 Dunbar Kapple 01169903 dod 5-51
The only good sports car that America ever made was the Jeep."
--- Enzo Ferrari
All times are GMT - 6 Hours Goto page Previous1, 2, 3
Page 3 of 3
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
