Posted: Mon Jun 10, 2024 12:15 pm Post subject: Rubber washers on F134 valve cover by
DCAK, Asked me this question in a PM and since we are a site meant to enlighten all our members by sharing our questions with all members so all members can benefit from the answers, I am posting it here for him.
Quote:
I have a valve cover gasket set that for F-134.
Came with 2 large rubber washers and 2 crush washers.
All were missing when valve cover was removed.
Does the rubber go on the inside or outside. Same with crush washer inside or outside? Are there any other washers that should be there?
Is there any any photos in your album?
The ORD 9 is very vague in listing the rocker cover and it's hold down hardware.
The Engine and Clutch Manual TM 9-8015-1 on pages 141 & 142 Par. 144 (o) covers it in great detail. However there is no mention of a crush washer.
https://1drv.ms/i/s!AqEz4MqcTZDBgs1imC6T_g55uvt9rw?e=nZ90g8 Copy entire link and paste in new page _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: Oct 02, 2014 Posts: 1955 Location: South Carolina, Dorchester County
Posted: Mon Jun 10, 2024 1:24 pm Post subject:
Assuming the question is about the intake valve (rocker arm) cover and not the exhaust valve cover?
If it helps, my Willys Jeep Universal Service Manual shows the order of assembly in Figure 100 on page 78 and describes it in Paragraph E-106 on page 85.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
