Joined: Apr 11, 2005 Posts: 174 Location: Coventry, RI
Posted: Sun Apr 30, 2006 11:59 am Post subject: Assembly help
Hi all. Bought my M38 semi disassembled so need some help here. Where do the speedometer cable and wire from regulator to dash enter the fire wall? What is correct routing of e-brake cable after it exits the dash??? Thanks in advance!!!!
Rick C
Routing of the hand brake (emergency) cable follows the frame and is attatched by a couple of clips and then a spring at the end to keep tension when releasing.
Will see if I can dig up some photos.
hope this helps. _________________ Ryan Miller
MVPA # 22010
You start by going thru the correct hole on the far left (driver's) side of the firewall then theres on clamp down low on the aft end of the left fender's inner skin then you courve back (staying of the left side of the engine) to the rear engine crossmember. Just avoid the cable rubbing on anything moving or hot. Then the photos tell the rest. The cable clamp (shiney bolt/nut) are an improvised clamp.
Joined: Apr 11, 2005 Posts: 174 Location: Coventry, RI
Posted: Mon May 08, 2006 12:53 pm Post subject:
Ok. Tried 6 times to open that PDF file but all I get is a frozen computer. Can someone clue me in on what holes the speedo cable and regulator harness goes thru???
Thanks
Rick C
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum