Posted: Sun Dec 04, 2011 5:35 pm Post subject: rust on pinion shaft bearing surface
I have a NOS ring and pinion set and the pinion has rust damage from poor storage. Is this pinion OK to use? Can it be cleaned, or needs repair, , or is it garbage?? I tend to think the bearings are pressed on so it may not be a big factor but I don't know.
Depends on the seriousness of the pitting. Large pits can lead to stress risers that lead to early failure. If they are quite small I would bead blast the pitted area and then prime it with a Glyptal type primer and use it. Larger pits could have their rough edges smoothed out and the same Glyptal type primer. A lot will also depend on how hard you intend to run the gears. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum