Joined: Nov 05, 2009 Posts: 174 Location: Florianopolis, Brazil
Posted: Tue Dec 07, 2010 7:40 pm Post subject: M170 distributor ventilation
Hi,
I finally ended up installing vaccum lines of my M170. Engine works like a clock, all engine job done.
Mine is a 1962, has no deep fording and vaccum/air boosting is restricted to engine crankcase+distributor+windshield wiper motors.
My question: how can I test if the vaccum produced by the fuel pump (vaccum diaphragm) is enough to ventilate and ensure cooling of the inner distributor mounted coil? I have a feeling that the air flow is very little. Vaccum for the windshield wiper motors is poor as well. HELP!
Thanks!
Claudio
Florianopolis, Brazil
42MB, 52M38, 42WC57, 62M170, 67M170, 69M606A3, 53Willys, 51D&K M100
Joined: Jun 20, 2010 Posts: 76 Location: Wiltshire UK
Posted: Wed Dec 08, 2010 8:02 am Post subject:
Hi Claudio,
I had a similar issue which wes heped me with on my M38A1. it is in the postings, I will try to find it.
Andy _________________ Andy
M38A1 & M416A1 trailer
Joined: Jun 20, 2010 Posts: 76 Location: Wiltshire UK
Posted: Wed Dec 08, 2010 8:12 am Post subject:
just found 2, "stuttering" and "M38A1 vacuum pressure", Not sure if this helps but I think I have read that the M170 has a similar system to the M38A1.
andy _________________ Andy
M38A1 & M416A1 trailer
I am not home this week so I do not have the numbers handy. You connect a vacuum gauge to the wiper side of the wiper "T" on the upper left rear side of the engine. The correct vacuum reading is listed in the service manul under the fuel pump specs. If you have less then that figure check to make sure the restrictive orifice is in the side of the "T" fitting that feeds the distributor. If it is and you have a low reading then your vacuum boost from the pump is not adequate. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum