hole locations

[circleburner12]

needing the correct hole mounting location and dimensions for the rear reflector. installed a new rear panel and the needing the info. thxs
_________________
1953 m38a1 1953 m100

[chrisk]

Hi circleburner12,
See my member album "sinrisnekaf"on page 8.
There is an image Dimensions Rear Panel page 2of2, the location of the reflector is outlined in red.
Chris
_________________
2x 1956 M38A1(Nekaf);1954 1/4TON trailer,Polynorm(Dutch);1983 Honda VF750C (Magna)

[circleburner12]

thxs chrisk, unless im missing something, the dimensions you speak of on page 2 is for the jeep. im asking for the reflector mounting holes for the m100. thxs
_________________
1953 m38a1 1953 m100

[chrisk]

Sorry, overlooked that it is a M100 trailer.
Chris
_________________
2x 1956 M38A1(Nekaf);1954 1/4TON trailer,Polynorm(Dutch);1983 Honda VF750C (Magna)

[circleburner12]

thanks anyway.
_________________
1953 m38a1 1953 m100

[jeepman]

Circleburner,I just when out and checked my 52 M100 rear panel.It just happens my reflectors are not reinstalled yet,Here are the dimensions I found.These are all measured to the center of the holes.The holes are 4 inches in from the side end of the rear panel,Note this is the end of the panel not the box side.The bottom hole is 2 and 15/16 inches up from the bottom edge of the panel itself not the frame rail.The top hole is 6 and 7/8 inches up from the bottom edge of the panel.Hope this helps.I would drill the bottom holes first then use your reflector to mark the top hole for a good fit.

[circleburner12]

jeepman thank you. thxs
_________________
1953 m38a1 1953 m100