View previous topic :: View next topic |
Author |
Message |
Ryan_Miller Site Administrator
Joined: Apr 03, 2005 Posts: 1634 Location: Kansas
|
Posted: Sun Sep 10, 2006 1:07 pm Post subject: Fuel brass T where primer pump is concected |
|
|
I am correct in reading that at the connection of the dash cold weather primper pump fuel line to the main fuel line at the "brass T" there is a ball check valve.
If so, where can I find one? I am going to check at the local parts store that carries more stuff than the national syndicated stores. _________________ Ryan Miller
MVPA # 22010 |
|
Back to top |
|
|
OKCM38CDN Guest
|
Posted: Sun Sep 10, 2006 1:59 pm Post subject: |
|
|
Ryan,
Check with remi edmond over on the For Sale Board, he had them...
Hope this helps... |
|
Back to top |
|
|
Ryan_Miller Site Administrator
Joined: Apr 03, 2005 Posts: 1634 Location: Kansas
|
Posted: Sun Sep 10, 2006 4:23 pm Post subject: |
|
|
Hal,
Here is a photo just to make sure we are on the same page.
Just off the brass T , the line going upward to the dash pimer pump.
At the T just before the primer pump line hooks on is where the ball valve should be, right?
And while I am asking. I have been trying to look up the size of the brass fitting at the fuel line to the carb.
_________________ Ryan Miller
MVPA # 22010 |
|
Back to top |
|
|
OKCM38CDN Guest
|
Posted: Sun Sep 10, 2006 5:24 pm Post subject: |
|
|
Ryan,
To my understanding this is the same ball check valve that is used on the underwater vent line from the fuel/vaccum pump to the Bell housing /Transfer case...
All fuel lines are 1/4" on the M-38... The M-38A1 were 5?16"... per the SNL...
Hope this helps... |
|
Back to top |
|
|
Ryan_Miller Site Administrator
Joined: Apr 03, 2005 Posts: 1634 Location: Kansas
|
Posted: Sun Sep 10, 2006 6:12 pm Post subject: |
|
|
Thanks Hal,
That is what I was thinking also. _________________ Ryan Miller
MVPA # 22010 |
|
Back to top |
|
|
wesk Site Administrator
Joined: Apr 04, 2005 Posts: 16256 Location: Wisconsin
|
|
Back to top |
|
|
Ryan_Miller Site Administrator
Joined: Apr 03, 2005 Posts: 1634 Location: Kansas
|
Posted: Sun Sep 10, 2006 7:50 pm Post subject: |
|
|
Wes,
That was a photo of Ben's and Luciano's set up.
What kind of tapered connector is that? _________________ Ryan Miller
MVPA # 22010 |
|
Back to top |
|
|
wesk Site Administrator
Joined: Apr 04, 2005 Posts: 16256 Location: Wisconsin
|
|
Back to top |
|
|
|