Posted: Sat Sep 03, 2005 11:38 am Post subject: Fuel Tank Question...
Well folks, I have received my new MD Juan gas tank. It looks ok at first glance, but the slots for the Cap do not line up correctly to place the bars/tabs on the cap level with the ground, no big deal, but is incorrect. Also the sleeve/strainer will not go into the tank, I think this is due to them primering the fuel inlet inside...
I have not test fit it as of yet, my tank has fuel in it and do not want to mess with fuel today, it is HOT here in OKC.
My question is this, if all goes acceptable with the test fitting of the tank, should I coat the inside of the tank with a tank sealer as added insurance and longer life. My thoughts were to treat the inside of the tank with POR-15 treament for fuel tanks. Then paint the tank and mount the sender and filter/gas line fittings...
Have you reviewed Ken Perkin's post on the fitting of his new MD Juan tank?
As for coating there are many choices. POR 15 is just the new guy on the block and gets a lot of unearned praise. There are products out there from companies that specialize in fuel storage systems. Since your tank is from the MD Juan collection then the metal will need help since they don't provide a chemical or electrcially bonded corrosion proofing for their steel.
I wish someone would start doing these tanks in aluminum. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: Apr 03, 2005 Posts: 271 Location: Chester County, PA
Posted: Sun Sep 04, 2005 5:09 pm Post subject:
Whatever you do, coat it with something.
I agree Wes - Aluminum would be nice but would be a freakin fortune. We bought a small sheet of Aluminum for our airplane, I forget the demensions, but it was the smallest Yarde Metals supplied - and it was somewhere around $400, I want to say? Just for a piece of bloody sheet metal. _________________ Bob Collins
1954 M38A1 MD79056
Bob,
Your $400 quote would get you a 4' by 55' sheet of 2024T3 aircraft aluminum in .032 thickness which is the most commonly used aircraft skin thickness. (That's 220 sg ft at $1.81/sg.ft. or in a 4" roll it's $13.75/running ft. or $16.29 for 9 sg.ft.
4130 steel sheet in .032 is $4.72/sg.ft. or $42.50 for 9 sg. ft.
As you can see the aluminum is clearly a bargain over the steel. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum