Joined: Oct 04, 2010 Posts: 32 Location: Van Buren, AR
Posted: Sun Oct 17, 2010 9:32 pm Post subject: Clutch Problem
i have a m38a1 and i was wheeling with it and the clutch was working great always had pressure on the pedal and all the sudden theres no pressure i checked the linkage underneath and i unhooked the one goin inside the trans and i can move it back and forth no problem
Are you saying you can move 18 rearward several inches with it attached to the fork? If the cable 18 moves fore and aft freely then the fork has slipped off the ball inside the bell. You can experiment with mechanical fingers thru the side opening and the top inspection plate but you may have to pull the engine. I say engine because I don't care for laying on my back on the floor pulling the tranny and transfer which is actually more work then pulling the engine. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: Oct 04, 2010 Posts: 32 Location: Van Buren, AR
Posted: Mon Oct 18, 2010 6:35 pm Post subject:
Well I pulled the inspection plate and I believe it's the throwout bearing it's locked up and sparks so guess I'll be putting a bearing in just gotta find a good cheap place
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
