Search found 37 matches

Hi Guys,

My M38A1 runs great but only the fuel gauge works. The pressure gauge I think works , it reads 60 when powered up and grounded to the block, it needs a 0-60 sender because the ...

Hi Guys,

My M38a1 breathed its first breath on Wed evening. It ran great but none of the electric gauges worked but thats something i can look into later. Thanks for all the help and ad ...

Hello,

I am getting ready to start my M38A1 for the first time. I dont know if any of the gauges work but I would like to know if there is any way to test the oil gauge to see if it would work ...

Hi Guys,

I am trying to install vacuum wiper motors on my M38A1 windshield. I know there are spacer blocks, copper tubing and tee's. Does any one have a few detailed pics of the wipers and ...

Hi Guys,

I am painting the windshield frame and will be replacing the gasket. Can someone tell me how I should go about installing the glass and gasket in the frame? Thanks.

Regards,

P ...

Hello,

I had the engine in my M38A1 rebuilt. I need to find out how to time the engine. The distributor was out when the engine was rebuilt and the hole was taped over, I put the distributo ...

Hi Guys,

I had my water pump rebuilt. There was a clip sticking out of the slot cut in the pump housing on the left side when facing the pump, and it fell out as I was cleaning it for paintin ...

Thanks Wes for the pics. Wes is the door upper channel bolted or welded on? Thanks again.

Paul

Hi Guys,

I want to put a full top on my M38A1. Does anyone know if there are 3 footman loops that go on the tub to hold the side curtains down?
Any pics of the sides of the tub with all at ...

Hi Lee,

Thats what I did. McMaster Carr had the allen head screws. As long as they work.

Regards,

Paul

Hi Guys,

My 52 M38a1 needs the 4 screws for the lower windshield bracket. Does anyone know where I can find those? I tried Midwest Mil, Bensingers, Beachwood all the usual suspects. Any hel ...

Thanks Ryan.

Hello,

The data plate that came with the jeep is at the minimum tarnished and unreadable. What can be used to get the brass shiny enough to be readable, assuming the plate is brass? Will ...

How do the gauges come apart?

Paul

Try Warn winches. I know you can get both 12 and 24 volt models. I am changing a Model 8000 from 12 to 24 volt. BTW where in northern Michigan do you ride?

Paul


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.