Search found 27 matches

I have a master cylinder heat shield that I would like to put on my M38A1, but I can not figure out how/where the shield attaches. It only has two brackets that almost looks as if it slides on somewhe ...

The Jeep started this morning, came back about 2 hours later and it will not start. I put a new coil in it so I don't thimk that is the problem. You mentioned compression, what range should each cylin ...

My 55 M38A1 is having starting issues. When it starts it runs great. Perfect, no miss and accelerates fine. I can cut the engine off and it will start with no problems at all if I immediately start it ...

I finally got a rear seat for my 1955 M38A1. I need pictures of the brackets and hardware(bolts,washers and sizes) as well as how it all atttaches to the tub. A few months ago someone had some great p ...

The carb in my 1955 m38a1 isnt functioning well even though I put a new kit in it. Are there any places that I could ship my carb to to get it rebuilt? Someone that is trustworthy and reasonable. Anyb ...

YS carb, no problem with the humor.

ok, thanks!

Thanks, but what exactly should I look for or adjust. I did rebuild the carb.... new kit. The level of the float? There are only two adjustment screws on the outside. What else can I adjust?

Should I be using the highest octane of gas in my 1955 M38A1 or the cheap stuff(87 Octane)?

My 1955 M38A1 is putting off a foul odor, much like a sewer(sulfer type smell). This occurs after driving it about 15 minutes or so. It leaks oil and is currently missing like crazy. Could the smell b ...

I installed a reproduction 24 volt oil gauge on my M38A1. The pressure is wrong, way too high( reading 100 plus). Why is this? My old guage stop working after my battery blew up. I changed my oil send ...

Are there any swap meets in the Kentucky area within the next two months? I really need some used parts for a CJ2A and two CJ5s. Especially tailgates and seat frames as well as other odds and ends.

Anybody in the Kentucky area with used CJ5 and CJ2A parts? Thanks

My M38A1 appears to only leak oil around the front(bottom) of the bellhouse when I turn the engine off, not while its running. Is this the rear main seal?

What is the best way to clean out an old fuel tank? Aside from shaking out all of the debris, is there a good liquid solution to help cleanse it out? Or just use gas?


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.