| Author |
Message |
 Topic: TM9-8015-1 Clarification |
cobra5
Replies: 2
Views: 422
|
 Forum: Technical Knowledge Base Posted: Fri Mar 29, 2024 3:02 pm Subject: TM9-8015-1 Clarification |
| Thanks for the clarification Wes |
| Topic: TM9-8015-1 Clarification |
cobra5
Replies: 2
Views: 422
|
Forum: Technical Knowledge Base Posted: Fri Mar 29, 2024 11:08 am Subject: TM9-8015-1 Clarification |
| I have an engine with an oil pump that was installed 180 out by the previous owner during rebuild. Finally getting around to correcting this problem. On page 117, step g. of the manual, it states to ... |
| Topic: Reputable Willy's mechanic in Jacksonville Area |
cobra5
Replies: 7
Views: 2307
|
Forum: Wanted Posted: Thu Oct 13, 2022 12:23 pm Subject: Reputable Willy's mechanic in Jacksonville Area |
| So was the oil pump indexing the problem? |
| Topic: Reputable Willy's mechanic in Jacksonville Area |
cobra5
Replies: 7
Views: 2307
|
Forum: Wanted Posted: Sun Oct 09, 2022 10:08 am Subject: Reputable Willy's mechanic in Jacksonville Area |
| This is what I would do if it was me. Remove the #1 spark plug and put a compression tester in that hole. Take the distributor cap off and rotate the engine by hand until you see compression on the #1 ... |
| Topic: M38A1 Starter Parts |
cobra5
Replies: 2
Views: 1171
|
Forum: Technical Knowledge Base Posted: Sat Sep 17, 2022 10:59 am Subject: M38A1 Starter Parts |
| There is a member on here that goes by BCA and his name is Brian. He is located in Canada and has NOS starter parts. PM him to see if he can help you out. |
| Topic: M38A1 crank but not starting |
cobra5
Replies: 33
Views: 7851
|
Forum: Technical Knowledge Base Posted: Sat Jun 25, 2022 3:16 pm Subject: M38A1 crank but not starting |
| Is the distributor rotor spinning when the engine is cranking? All connections clean and tight inside the distributor? Have you performed the ohms check on the coil yet? |
| Topic: M38A1 crank but not starting |
cobra5
Replies: 33
Views: 7851
|
Forum: Technical Knowledge Base Posted: Sat Jun 25, 2022 2:21 pm Subject: M38A1 crank but not starting |
| The other thing that will prevent you from getting spark is the ignition switch |
| Topic: M38A1 crank but not starting |
cobra5
Replies: 33
Views: 7851
|
Forum: Technical Knowledge Base Posted: Sat Jun 25, 2022 6:28 am Subject: M38A1 crank but not starting |
| If it ran before you parked it, use a piece of sandpaper and clean the contacts on the breaker points and than check again for spark. |
| Topic: M-38A1 Fuel Tank - SOLD |
cobra5
Replies: 4
Views: 8827
|
Forum: For Sale Posted: Wed May 18, 2022 5:15 pm Subject: M-38A1 Fuel Tank - SOLD |
Hal,
I finally got around to working on the fuel tank. Took me about 2 hours with a propane torch and a scraper to loosen and remove the fiberglass and resin. Whomever put the fiberglass on the tan ... |
| Topic: 24 v M38 Starter - best offer |
cobra5
Replies: 4
Views: 2702
|
Forum: For Sale Posted: Fri Apr 22, 2022 1:16 pm Subject: 24 v M38 Starter - best offer |
| PM sent |
| Topic: 24 Volt Coil |
cobra5
Replies: 5
Views: 2697
|
Forum: Technical Knowledge Base Posted: Thu Jan 27, 2022 1:28 pm Subject: 24 Volt Coil |
| You realize that those NOS coils are 30-40 years old and do degrade over time. You might get lucky and get a good one and it may last 1- 5 yrs or a week. The good thing about Debella is he will stand ... |
| Topic: M170 versus M38A1 Wiring |
cobra5
Replies: 1
Views: 2440
|
Forum: Technical Knowledge Base Posted: Sun Nov 21, 2021 10:01 am Subject: M170 versus M38A1 Wiring |
I think I found what I was looking for from 2015
http://www.willysmjeeps.com/v2/modules.php?name=Forums&file=viewtopic&t=9901 |
| Topic: M170 versus M38A1 Wiring |
cobra5
Replies: 1
Views: 2440
|
Forum: Technical Knowledge Base Posted: Sun Nov 21, 2021 8:38 am Subject: M170 versus M38A1 Wiring |
| Has anyone ever modified a M170 harness to work in an A1? I assume the M170 harness has some longer runs for the rear lights and additional wiring for the emergency light reel. I've already looked ove ... |
| Topic: SOLD---NEW OR GOV. REBUILT M38 & M38A1 AC FUEL PUMP & |
cobra5
Replies: 3
Views: 2927
|
Forum: For Sale Posted: Sat Oct 23, 2021 11:16 am Subject: SOLD---NEW OR GOV. REBUILT M38 & M38A1 AC FUEL PUMP & |
| I'd be interested in the pump if its still available. |
| Topic: Miscellaneous M38A1 parts |
cobra5
Replies: 9
Views: 10198
|
Forum: For Sale Posted: Sun Oct 03, 2021 9:10 am Subject: Miscellaneous M38A1 parts |
| PM sent |
| |
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
