Joined: Jan 31, 2017 Posts: 72 Location: Salt Lake City, UT
Posted: Fri Mar 03, 2017 10:08 pm Post subject:
Thanks for that link, just got those hinges delivered today!
Weather finally started to clear up so I was able to start working again. Decided to tackle the transmission and transfer case rebuilds first. Got everything pulled off except for the clutch linkage. That is causing me a few problems since I am not pulling the motor out...
Joined: Jan 31, 2017 Posts: 72 Location: Salt Lake City, UT
Posted: Thu Mar 09, 2017 10:32 pm Post subject:
Just got the bell housing/tranny/transfer pulled out today. Had some rust on the input shaft keeping it from sliding apart as it should. A can of PB blaster, some ratchet straps and a 25lb sledge hammer got everything apart. Letting everything drain tonight before I start dismantling each piece. I certainly noticed some rust on the gears and I think I saw some pitting... Crossing my fingers it isn't too bad.
All times are GMT - 6 Hours Goto page Previous1, 2
Page 2 of 2
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
