As a general rule in maintenance, anytime a procedure does not list a torque for a fastener and the fastener is not listed in the manuals torque listing then proceed to a "Standard Torque Chart for the grade fastener being torqued and use that figure. You must know the grade (IE grade 5 or grade and the size/thread pitch of the fastener. Go to the ORD 9 SNL G-740 page 52 and you find the bolt (Or screw if you believe the parts list) is a Screw, cap, hex-hd, 5/16-18NC-2x1 1/16.
You can google up a "Standard Torque chart for a Grade 5 bolt or use one from my photo album. I would suggest you go to my album on torque and print the 5 pages shown there. Study them and then select an appropriate torque from the page 5 chart.
I know these WWII series manuals up thru the 50's lack a general torque chart but the Army finally got their act together in the late 60's and started including them. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Good catch RG. I missed that when I looked in SM 1002 torque list page 285. For some reason they list the flywheel under the "Engine" section and the pressure p[late under the "Chassis" section.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
and the size/thread pitch of the fastener. Go to the ORD 9 SNL G-740 page 52 and you find the bolt (Or screw if you believe the parts list) is a Screw, cap, hex-hd, 5/16-18NC-2x1 1/16.
