The norm is to use a Standard Torques Chart anytime a specific torque is not listed for an application. To determine the torque for a fastener in the general torque charts you must first ID the fastener. (Diameter, thread pitch, SAE Grade, and material. You can find this info usually in the applicable parts manual.
Unfortunately the Army failed to include one in the vehicle specific manuals.
There are many on the internet that you can download. Just ask for an "Automotive Standard Torque Chart. The Willys/Kaiser civilian manuals do have short listings for specific parts in their appendix but no general charts. The CJ5 Service Manual SM 1046 is you best bet for civvy manual help. The Application Specific Torque charts and the general torque charts I have posted in my photo albums.
Joined: May 12, 2018 Posts: 93 Location: Austin Texas
Posted: Mon Jan 27, 2020 3:03 pm Post subject:
I bet it's in the 30-40Ft.Lb region. That pulley only needs to hold onto the shaft as a keeper. A key on the shaft actually transfers the torque so it should not be some gorilla strength item!
That is pretty thoughtful but would not be the determing factor since the bolts secure the fan to the pulley and pulley to the pump flange rotational torque is being applied directly to the 4 bolts by the fan when it is turning while the belt is driving it.
Rather then guess at a torque the simple plan is to just ID the 4 bolts and select the correct torque from the general torque chart.
The Bolts are 1/4-20 Zinc plated and usually grade 5 so the standard torque would be 10 Ft Lbs. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: May 12, 2018 Posts: 93 Location: Austin Texas
Posted: Tue Jan 28, 2020 12:44 am Post subject:
OK I thought this was in reference to the pulley for the generator.
If on the water pump flange then agree with the info above. Believe those are only 1/4" bolts so not a huge amount of torque since there are four of them working together.
Looking at the title again it appears we both were off the spot a bit. Not the water pump pulley and not the generator pulley. Instead I think he is looking for the torque for the crankshaft pulley nut which is a 1 1/16" -16 NF nut and all my charts only address 1 1/8" or 1" which puts the torque range in a shear application at 180 to 300 Ft Lbs. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
