Posted: Sun Jun 07, 2020 1:32 pm Post subject: M38A1 - setting proper timing.
Hi fellows,
I am facing the following problem:
- I installed a rebuild distributor built from nos parts.
- using a stroboscope lamp, running with approx 800rpm, I turned the distributor clockwise. But even when reached the maximum possible angle (the distributor housing then is horizontal) I do not reach the 5° marking on the housing.
- Interestingly the wires are not positioned as they should:
Would it help to switch wire "1" to wire "3" counterclockwise and simultanelously turn the distributor counterclockwise also? I should be able to reach the 5° tdc marking then, correct?
Or what is the best way to reach 5° befor tdc?
I appreciate your help!
Philipp _________________ ´57 M38A1
Ramsey 50R setup
USMC spec. PowrLok front & rear
Meyer ST 84 plow
First the oil pump must be indexed correctly with #1 piston TDC on compression since the oil pump is driven by the cam and the oil pump drives the distributor. This is the most overlooked step in final engine assembly on this planet. It is not that critical on civilian jeeps because they use a distributor with a small round housing. The much larger oval housing of the military distributor will contact the block before it can be rotated far enough to set timing correctly if the oil pump is not first indexed correctly.
Second the cap wire sequence is incorrectly illustrated in TM 9-8014 Fig 79.
Joined: Jul 10, 2018 Posts: 97 Location: Western Washington
Posted: Mon Jun 08, 2020 11:41 am Post subject:
I attempted to set it close before I ever started mine. My engine had been rebuilt and never ran. I could not get close to the proper setting. I realized the oil pump shaft was set 180 degrees opposite of correct. Off came the pump, turned the shaft 180, and good to go.
Yours is probably indexed incorrectly. Follow the TDC instructions to find out. _________________ Rick Eades
1951 M38 & 1967 M715
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum