Posted: Sun Apr 14, 2024 1:32 pm Post subject: M38A1 Slave Bucket location
I had to replace the passenger side panel. I need to replace the slave bucket . does any one have the Measurment from the front of the panel and top of panel . close would be good.
Joined: Apr 03, 2005 Posts: 271 Location: Chester County, PA
Posted: Sun Apr 14, 2024 10:24 pm Post subject:
I have a 1954 M38A1. I'm not aware of this geometry changing substantially over the production run, but I am not sure.
Edge of panel to center is shown below. I'd appreciate it if someone else could check.
I assume you saved the "bucket" although I am not sure how much you were able to save of the right side panel. The right side panel is formed so that the top surface of the bucket lip / flange sits coplanar with with the top surface of the right side panel.
The actual receptacle housing / "bucket" is a formed/drawn part.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum