Posted: Tue Nov 14, 2017 9:05 am Post subject: Transmission Shifter Box Gasket
Hello. I am about to make a gasket (642770) for between the shifter column box and the top of the T90 transmission. The previous owner only used RTV so I don't have an old gasket to compare. I live in Canada and although a new gasket is only $2, it will cost $25 to ship it here.....So, my question is how thick is this gasket? Is it a paper thin one or is it about the thickness of a cereal box? _________________ Regards
...Wes
Joined: Aug 22, 2016 Posts: 117 Location: Huntsville, AL
Posted: Tue Nov 14, 2017 10:09 am Post subject:
My new gasket was about match book thickness...a little thicker than paper thin and i used gasket sealer spread thin on the gasket and case when putting the shifter on.
My new gasket was about match book thickness...a little thicker than paper thin and i used gasket sealer spread thin on the gasket and case when putting the shifter on.
Joined: Nov 24, 2010 Posts: 1390 Location: Orem, UT
Posted: Tue Nov 14, 2017 4:32 pm Post subject:
I just used a manila folder as a gasket and indian head shellac.
Its easy to make a template, just place a piece of printer paper over the case opening and run a slightly dirty finger over the edges. It will show up enough that you can cut it out and transfer that to your gasket material of choice.
Brett
Or another method is to place the gasket material layed on the housing opening that you intend to seal and go around tapping the edges with a peen. This will cut it as you go along. Sometimes its hard to hold it in place though doing it this way. _________________ Brett
'51 M38
PHOTO DIARY OF MY BUILD
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum