Joined: Dec 28, 2017 Posts: 194 Location: Salamanca,NY
Posted: Mon Aug 20, 2018 10:18 am Post subject: a1 rear axle reassembly
I am starting to reassemble the rear axles and have been referencing tm-8014 and 8015 but I want to make I am doing everything correctly. So here is where I am so far. I repacked the bearings and inserted the axles back into the tubes next I slid the bearing cones into place and drove them in until they were flush with the shims. I did this on each side which resulted with roughly 1/16th end play. I then reassembled everything on the d/s stopping with the oil slinger. I am not sure how to proceed from here.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum