Create an account Home  ·  ·  Forums  ·  ·  Articles  ·  ·  Downloads  ·  ·  Photo Gallery  
Login
Nickname

Password

Don't have an account yet? You can create one here.

Navigation
· Home
· Article Archive
· Article Submit
· Downloads
· FAQ
· Forums
· Members List
· Photo Gallery
· Private Messages
· Web Links
· Your Account

Search Articles



Forums

M38 Main Wiring Harness install under dash mounting
Wiring Harness Packard Connectors
M38 Wiring Harness Transister Flash Turn Signal Unit Mount
Sputtering from exhaust pipe
Wanted M100 or M416 Trailer
Hood numbers 20 prefix VS. 23 prefix
M38 crankshaft nut size
Miscellaneous M38A1 parts
2- M38A1 24 volt horns
photo gallery request

Willys M Jeeps Forums


willysmjeeps.com :: View topic - quality clutch advice
 Forum FAQForum FAQ   SearchSearch   UsergroupsUsergroups   ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

quality clutch advice

 
Post new topic   Reply to topic    willysmjeeps.com Forum Index -> Technical Knowledge Base
View previous topic :: View next topic  
Author Message
BB
Member


Joined: Feb 14, 2014
Posts: 21
Location: Dunedin, Florida

PostPosted: Fri Feb 28, 2020 10:46 am    Post subject: quality clutch advice Reply with quote

I am looking for advice on an 8.5 inch clutch and pressure plate, brands and their quality for my m38. I plan on adding an overdrive later also. I have a duralast set available locally for $128.00 but I dont want junk, any comments from experiance would be great .
Brian
Back to top
View user's profile Send private message
jam51m38cdn
Member


Joined: Feb 06, 2008
Posts: 66
Location: Findlay, Ohio

PostPosted: Sun Mar 08, 2020 7:15 am    Post subject: Reply with quote

Years ago after i first got my M38 I used it for plowing snow, and I thought that I was smoking my clutch by doing so. I put a new one in only for it to do it all over again. After closer examination I found it wasn't the clutch or pressure plate at all. It was the elongated holes in the bellcrank and that the linkage rods that were almost worn through. Those seem to go bad due the lack of lubrication, not a very good setup in my opinion. Rolling Eyes
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    willysmjeeps.com Forum Index -> Technical Knowledge Base All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Powered by phpBB © 2001 phpBB Group
Forums ©

 



PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.