| View previous topic :: View next topic |
| Author |
Message |
OKCM38CDN
Guest
|
 Posted: Sat Mar 22, 2008 8:58 am Post subject: Top Bow Measurements... |
 |
|
I know this has come up before, did a search and could not find it...
I have a set of reproduction top bows, they do not come with the holes drilled in them for the rods to the windshield... I need the measurements from the pivot point to the holes...
Thanks... |
|
| Back to top |
|
 |
tdavis
Member
Joined: Nov 25, 2007
Posts: 56
Location: Marietta, Georgia
|
|
| Back to top |
|
|
OKCM38CDN
Guest
|
| Posted: Sat Mar 22, 2008 4:57 pm Post subject: |
|
|
This covers all but the measurement I need...
The measurement to the holes for the brackets to the winshield was not covered in this discussion... |
|
| Back to top |
|
|
tdavis
Member
Joined: Nov 25, 2007
Posts: 56
Location: Marietta, Georgia
|
| Posted: Sat Mar 22, 2008 6:38 pm Post subject: |
|
|
This part wasn't what you needed?:
| Quote: |
Dwg 2:
A - 32.5
B - 39.5
I added the following:
C - 3 (Inside radius of bend in bow tubing at top of bows - same on both)
D - 25.75 (End of bow to ctr of hole for top bow rod on outboard side of short bow)
E - 0.375 (Top bow rod hole diameter)
|
_________________
Troy Davis
1953 USMC M38A1 (Work-in-progress)
Rebuild Blog: http://troy-m38a1.blogspot.com/ |
|
| Back to top |
|
|
OKCM38CDN
Guest
|
| Posted: Sat Mar 22, 2008 8:47 pm Post subject: |
|
|
| Sorry, did not see that... was looking at the photos for what measurements were taken... |
|
| Back to top |
|
|
tdavis
Member
Joined: Nov 25, 2007
Posts: 56
Location: Marietta, Georgia
|
| Posted: Sat Mar 22, 2008 10:00 pm Post subject: |
|
|
No prob - let me know if you need any other measurements not on that post and I will run out to the garage and measure for you.
_________________
Troy Davis
1953 USMC M38A1 (Work-in-progress)
Rebuild Blog: http://troy-m38a1.blogspot.com/ |
|
| Back to top |
|
|
|
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
