Dimensions for M38 Data plate backing plate?

[avmechanic]

I am building a M38 jeep and need to make a steel backing plate for my reproduction Data plate set. I need the Dimensions for the backing plate that the data plates are attached to. I could also use a good picture of the layout of all the plates including the winch data plate so I can fabricate what I need. Thanks.
Greg

[wesk]

The late M38 and the M38A1 and the M170 all use the same mounting plate.





The plate is 10 7/8" wide by 7 1/4" high.

The four mounting holes for the plate are all 1/4" in from the side edges and 9/16" from the top and bottom of the plate.

The four corners are rounded at about a 3/8" radius.

The 3 left data plates left edges are 1/2" from the left edge of the mounting plate.

The 3 right data plate right edges are 1/2" in from the right edge of the mounting plate.

The data plates start 1/16" down from the top and end 1/16" up from the bottom. With equal vertical spacing.
_________________
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules.php?set_albumName=Wes-Knettle&op=modload&name=gallery&file=index&include=view_album.php

[avmechanic]

That is great. Just what I needed. I will get to work and make a plate up. Thanks.
Greg

[wesk]

http://img.mypicgallery.com/m38a1surveyguide/usmc-nos-edited-sm.jpg
Full size
_________________
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules.php?set_albumName=Wes-Knettle&op=modload&name=gallery&file=index&include=view_album.php

[G740]

You know, for $17 you can buy a new one from me.
John
Midwest Military