Posted: Thu Jun 24, 2010 5:44 am Post subject: L134 oil spray nozzle
Can anyone tell me where I can purchase an oil spray nozzle for the L134 engine?
Or can I just put an 1/8 plug in with a small hole drilled in it?
If so what size hole to drill.
You could make one. You would have to drill the center of the plug from the rear to create a hollow plug with the hollow probably about 2/3 rds of the diameter of the plug. Then temporarily install the plug and tighten slightly. Mark the side of the plug that faces the cam gear at a point just before it meshes with the crank gear. Remove the plug and drill a 0.040 hole in from the side so that the spray from that hole will strike the cam gear in about the middle of it's teeth width. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
If you can't find one of these at a vendor I would suggest either turn one on a lathe using 7/16" hex stock or get a short 2" or so 1/8" P steel nipple and cut it off at one end to make it 1 1/4" tall then take a 1/4" bolt and cut the head off leaving a short 1/8" to 3/16" stump of the shank. Then weld it in the the end of the pipe nipple. Then measure up from the threaded end and drill your 0.040 hole. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Thanks for the information . you have been a great deal of help.
I spoke with a fellow in vermont that thinks he has one to send me.
If not I have access to a mill and a lathe.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
