willysmjeeps.com

I am looking for a dead starter to salvage parts out of. Early M38 starter needed.

OK -got it now!

Thanks for the clarification

http://www.surfacezero.com/g503/data/50 ... G_1507.JPG


Are you saying this should not be fixed? How readily available is the repair unit?

I have the early starter

ok - I took the starter to the rebuilder - and the pinion gear (i think that is the right term) has a threaded end that keeps it in place and prevents it from staying engaged to the flywheel. the nut that holds it in place is broken. I am looking in my manual which shows an exploded view of the ...

Thanks all - points well taken - I am off to pull a starter!!!!

so the question is do you run it til it dies or pull it and rebuild it now?

it is such a pain in the ass to take out - has anybody found an easy way to get at the bolts without pulling the air filter etc....

at startup my starter is making a grinding noise from the front end of the starter - not at the flywheel. It stopped after about 30-45 seconds. I tried it again and got the same response. I checked the bolts to make sure it was fastened to the vehicle properly but the noise and vibration seems to be ...

My M38 will idle really rough if I haven't driven her for a while. After a few miles she then kicks right into full step - smooth as can be .

Any ideas as to waht could be causing this????

Arizona M37 for sale $10K

--------------------------------------------------------------------------------

I need to make room in my garage and this truck for sale will make someone a GREAT daily driver. I really love this truck but I just never get enough time to drive her. Runs great and all ...

http://cgi.ebay.com/ebaymotors/1953-Wil ... enameZWDVW


on Ebay - looks great

USMC m38A! in Tucson

http://tucson.craigslist.org/car/427385807.html

Looks good but I have too many vehicles already

Does anyone have pictures or manual locations for the locations and sizes of all of the canvas starps for the M38A1?


I am also looking for a wiring diagram for the A1

Thanks,

Thanks again Wes - your the greatest