willysmjeeps.com

thank you Ron and Wes.

I went through searches on bearing cross reference and went down a rabbit hole trying to hard to find other bearing references.

Ron, I drew a lightbulb moment afterwards on the manual download for the M38al.

Wes, as always, you have great responses. I missed that other ...

Yes they are the same Timken numbers.

Front:
Cone 18590 2 at each wheel
cup 18520 2 at each wheel

Rear:
Cone 25877 1 at each wheel
Cup 25821 1 at each wheel

Seal National 13710 1 at each wheel

Hi;

I have an M38, and I found this thread about the M38A1... I believe they both have Dana 44 rear ...

update:

Mike/Wes

took me longer to post this than the actual fabrication, but got it done. i wanted to say thanks for measurements and pics. I actually had to fabricate from scratch the front right one, and I had to replace the left frame portion as well.

http://willysmjeeps.com/v2/modules ...

IF you are looking for very good war movies lately, I highly recommend the forgotten battle, operation mincemeat, 1917, and dunkirk just to name a few.

MIke/Wes

thank you for that info and pic.

one last question if you don't mind....what would be the distance from the floor to the center of bend (before it goes to seat frame? Ball park. this should give the angle....it looks like the angle is about 30 degree bend but understand it also has to ...

Thanks guys. I appreciate the measurement as I know at least where mine needs to be.

Wes, thank you. Hi was actually looking in your album and saw those pics and realized I am missing mine. An oh shoot moment

Let me know if you happen to measure the bracket

Cheers and merry christmas

Thanks guys. I appreciate the measurement as I know at least where mine needs to be.

Wes, thank you. Hi was actually looking in your album and saw those pics and realized I am missing mine. An oh shoot moment

edit: the angle of the piece would also be appreciated as well. and if anyone has the ability to get me the measurement of the front right driver's side seat frame leg (from top of curve to floor). this is the short leg that would be on the transmission hump.

love the challenge of trying to figure ...

HI Wes.

I would greatly appreciate any measurements if you can provide....and if you can tell me the thickness of the material that would be great too. tThank you.


if anyone has plans of it, that would be awesome!

I have fabricated a few of the parts already. latches, heat shield, rear cross ...

Thanks Wes 2x.

I just figured out how to post pics in my album, so I was almost there!


thanks for the link to your album. I need to track one down!

Hi

i am wondering what is the purpose of the bracket welded to the underside floor of the M38 near the transmission hump on the hat channel


also was wondering if anyone has the dimensions for it as well. thanks! http://www.willysmjeeps.com/v2/modules.php?set_albumName=album682&id=hat_channel ...

Thanks ron. Really appreciate that.

One more quick question. What is length between bends?

Hi good discussion. I am looking for dimensions for the clamp strap that holds tank to the back floor on M38. Look for width and thickness of material

Well deserved. I cannot think of the number of times I have looked up something for my project only find that Wes or Ryan had answered it to the point. I am one who has been doing body and frame work first but as I move into the mechanical, I see another level of understanding with part references ...

Yikes that is quite the piece of work. Wonder I can just bid for the rad. Loll