willysmjeeps.com

I went to start my A1 the other day and the starter is dead no noise as if it wasnt getting any energy, batteries on a Trickle Charger and at 26.3 Volts at the Starter Switch terminals, I took the switch apart and cleaned up the contacts that didnt help same result no noise, so what Iam asking is ...

What is being used as a replacement for the original 'LEAD' washers that were used on the fuel tank sending unit and fuel filter, any help is greatly appreciated.... Thanks Scott

Wes Iam sorry that is a really old address I dont think ive used it in over 8 years I tried to change it but it tells me I cant please advise. Thanks, Scott

I have the manual for the install of the arctic kit, Iam not sure if its the original or a reprint though...... Scott O&O

curious did you drill a hole for the AB-15 in the top of the spare tire mount

Notice the person bidding it up has never bid on anything before. Scott O&O

Id like too mention download the manuals or buy them they will take you step by step on any problum you will find in the restore of your M38A1
Scott O&O

Lockout hubs in the rear were for flat towing, havent seen that mod since the '70s. Scott O&O

They mite of made improvements on the M38 tank but the A1 tank is a piece of crap for the amount of change they get for them. Scott O&O

your right, the reason you want the correct one is so you can remove the battery cap to check the water the way those mount defeats the purpose. Thanks for the info, Scott

were did you get the original type Positive & Negative Battery Terminals Ive found the Neg. but never the Positive inquiring mind needs too know. Thanks, Scott O&O

On your pic asking what these brackets are for, if there are 3 or 4 holes towards the bottom of the body directly below the half round one there would have been a antenna mast there it held the UHF antenna for the MRC FAC system or just A UHF radio. Scott out

In 1954 it would be stencils and decals

If you have the tailights with Douglas connectors you can remove the Packard connectors and replace with the Douglas there easy to take apart. Scott out

It should tell you on the data plate, if its the original