willysmjeeps.com

It's been a great experience and I've learned many things on this completed project. Now life is taking me in another direction.

1954 M38A1

$35,000, willing to negotiate.

Frame off restoration
Replaced front floor, rear panel, and patched every hole. It's solid
Beautiful, metallic, pearl green ...

11/16-24 is a little loose, UNEF is comparable to NEF-3 correct?

I was close... Much appreciated info, thank you!

Looked through ORD 9 SNL G758 for the Autolite 2245 spark plug thread size on the plug wire end, but only found the info below. I mucked up a couple threads and would like to clean them up.

"PLUG, spark, shielded, 14-mm, is/(6 hex, 35/si overall 4 (radio suppression wtrprf type)"

I'll be there Friday and Saturday with my A1, I was also chosen to represent 1954 in the parade! Stop by and say hi.

Trever

i saw this on craigslist, the guy selling it said he would take $400.

http://cincinnati.craigslist.org/pts/3752379771.html

i like the idea, and i think it would help with questions members have. they could read and research a few build threads before asking. along with giving us something to observe and enjoy.

i am getting ready to patch and fill all of bubba's holes that he put in the dash and windshield frame. i am looking for a few photos that will indicate all required holes and aid me in eliminating the unnecessary ones. i would like a couple close-up head-on photos of each piece. its for a 54 m38a1 ...

this is not the hood mentioned above, but i thought it was funny that these hoods have sequential numbers.

hi all, i have replaced the rear panel on my 54 m38a1 and now i am about to drill out the holes for the spare tire, jerry can, and trailer receptacle. i have searched the site and others but only found dimensions for the spare. will someone point me in the right direction? thanks trever

thanks guys for the advice. i definitely appreciate it.

1) when installing the clutch, is an alignment tool necessary?

2) i purchased a new flywheel and need to have the two guide holes drilled to fit onto the two tapered dowel bolts; does anyone know the tapering specs?

Hi, may i have a photo gallery please.