willysmjeeps.com

M38 starter MCZ-4001UT. SN G225194 This unit works and is good condition.
M38 25 amp generator, Autolite HA 4802BUT SN G532181. I have bench tested field and armature windings using ohm meter but have not tested on in my jeep.
Starter is $125 and Generator is $75.
For pick up in Lake Forest, Calif ...

Dave
My father in law was in Korea in the 187th Regimental Combat Team and I have a picture of him standing in front of 2 jeeps with unit markings which he said was taken in Korea. The front bumper is clearly shown and is marked:
187 RCT HQ5
This doesn't seem to completely conform to the ...

M38A1 original dual action fuel pump with priming handle. This is an AC pump and includes the mounting spacer and one of the long head bolts. The pump does need to be rebuilt as the fuel diaphragm is leaking. The flange number is 4260. $45 plus $12 shipping in U.S.
PUMP HAS BEEN SOLD

M38 early ...

Complete antenna system for Willys M38 or M38A1 military jeeps. Consists of brackets, base and antenna sections listed below.
MP50 antenna mount
SCC28592 corner bracket
AB-15 mast base
MS 116,117 & 118 mast sections
All parts are military surplus in good to excellent condition. The MP50 mount has ...

Thanks for the info Wes

This would be more of a motor pool resto at best.
I have the non vented cap (WO 805012). Since you indicate this wording was actually used I'll probably just recreate what was there.

My 52 M38 didn't have the typical "caution do not overfill allow for expansion" warning below the filler cap.
Instead it had "pressurized open slowly" on 2 lines to the upper right of the filler cap and " max accept rate 17GPM" on 2 lines just below the filler cap. Upon sanding this was evident on ...

Swampy
sent you a PM

I have a full set (front and rear) of what I think are the original seat springs for an M38. The springs are topped with a layer of jute and then a layer of foam. Springs are rusty but not broken. They were recovered in vinyl by some PO. I have replaced them with new foam seats and thought someone ...

Wes
There is no date on the kit that I can find.
I got it 2 years ago from one of the reputable suppliers and rubber is very supple. Parts were all sealed

I ordered an M38 rebuild kit a while back and instead received an M38A1 kit. The box was marked wrong which I didn't find out until I opened it up. Its an APCO kit. I can send pics if needed. $25

Can anyone tell me the correct length of the fording cables for a M38. I ordered one and believe it might be for M38A1 as one cable (PCV valve) is about a foot too long. I don't mind cutting it down but need to know how far. The cable I have is about 34" and 38" from dash flange to end of wire ...

Wes
Thanks for the pictures, that was exactly what I was looking for.
bob

I have a late M38 (May /52) am trying to determine correct routing of the 4 wires going to the headlight dimmer switch. Portions of the original harness was cut up and modified by PO and I am rebuilding it. Cant find any clear pictures in albums or manuals of routing to the dimmer. Do the wires go ...

You may want to check these out
http://www.armysurpluswarehouse.com/m38 ... e-set.html
Not sure what they are for but they do fit.

Thanks guys, I'm a complete goofball and spaced out on this. Ive only replaced about 10 of these.