willysmjeeps.com

Does anyone have a pair of USMC rear lifting shackles for the rear box bumper from an M38A1?

Thank You Sir!

Is there a trick to installing the speedometer cable in the M38A1?

In order to reach the back of the gauge the cable has to make a very sharp bend when it comes out of the T90. I have broken two cables at this point and I am thinking that I am installing the cables improperly. How should I be ...

citabra wrote:Please tell me that your wife or daughter made this observation and brought it to your attention, and that you were not actually watching this movie.

Truthfully, I was just happy it wasn't more Downton Abbey or another cussified episode of My Little Pony... I'm outnumbered here!

Look at what I spotted.



Basically, even after civilization has collapsed and the dead have overrun the planet Willys and Jeep will be there.

wesk wrote:M38 ORD 9 ref was for Rick.

I needed the diameters on the tubing. The tubing I found was so thick that it wouldn't all fit at the Y junction. Thanks again!

Thanks Wes. That is exactly what I needed!

Thank You!

Anyone have photos of their wiper motors installed? I am finishing my windshield up and I am wondering what type of hosing everyone has used for the supply of their vacuum system. Then I want to try and get the new tubing running in all the right places, above, below, behind, etc. The original ...

The mechanical vacuum/fuel pump in my 52 M38A1 is corroded and needs much TLC.

I have two questions.

The lower section of the pump contained a small amount of oil. Perhaps I have misunderstood something. I thought the vacuum system was dry. Is there supposed to be a lubricant in this system?

In ...

Thanks all. I will get busy pouring over every photograph I can find. If nothing turns up I will make the best guess for my Korean War display. Thanks again.

All,

I own a 1952 USMC M38A1. Is there a resource that I can use to identify the unit or division my Jeep was attached to? I have the original data plate listing the serial number as 18690. During my sanding and repainting, I was unable to recover any unit markings. I am lucky enough to have ...

Hello all,

These two motors came off my '53 M38A1 parts Jeep.

http://i1177.photobucket.com/albums/x354/voodoo4/Wipers/wpr0302.jpg
http://i1177.photobucket.com/albums/x354/voodoo4/Wipers/wpr0301.jpg

I confess my ignorance on the subject of the wiper motors. Can anyone tell me if either one of ...