willysmjeeps.com

oilleaker1 wrote:Ron Fitzpatrick Jeep Parts, WWW.G503.com sells double lip seals for the yokes, but if your yoke surfaces are grooved, you may need to replace the yoke, or install speedy sleeves. Midwest Military also has parts. John

Hi Ron, thanks for being prompt,

oddball

can any one help me with my front and rear diffs I have a slight leak of oil
from both diffs at seal were prop shaft goes in,
I cant find both kits at this time.
so can some one tell me is there a transmission oil lubricant seal that I could use just now,

or some one tell me were I can buy both ...

thank you.

great help.

oddball

Good Morning Guys.

I have a small [problem with my air flow system that works my tranco wiper motors,

I replaced the rubber tube that goes into the tranco as it was perishing and in doing this the passanger side works better than the driver side so I changed them over and its still the same,

does ...

thank you

eddie

Another Problem chaps.

my mate has an M38a1 and he lives in Scotland too and he is a member of the site, he goes by,,,Scotbish.

anyway his fuel tank is pitted with small holes, at bottom.
how would you help us to fix this problem.

he Knows that the obvious one is replace the tank,
but we cant ...

cheers WES.

your a star mate.

The DVLA in uk said that they would not except a fax copy of your findings for the month and year of the vehicle they want an original copy, so I have
e.mailed my military group and asked them to put your findings on a hard copy and post it to me as soon as I get that ...

engine is sound, I just came back from doing a round trip of 102 miles last weekend I was staying in SCOTLANDS SECRET BUNKER,

the jeep ran well I was so proud of her she she sat at 50mph on motorway with no hiccup.

I was in the garage last night and I dipped the engine level stick to check the oil ...

what engine oil flush should I use in my m38a1 before I change the
filter and oil.

cheers
oddball

In less than 90 Deg F weather and not more than 1/3 of the open grill area covered it should not be a problem.
thanks for that ..wes.

another thing the DVLA uk WANT AN ORIGONAL COPY OF THE SEPTEMBER 1952 THEY WONT TAKE A PHOTO COPY SO I AM HAVING MY MILITARY CLUB DRAW UP A LETTER TELLING THEM THE ...

wesk wrote:MD 18088 was manufactured by Willys in Toledo, Ohio, USA S
eptember 1952.

hi, i am after a little bit help can anyone tell me if the radiator fan will be restricted if i was to put a small wooden box on my front bumper of my willys jeep.

as i do 50 mile runs per day.

thank you

willy,s m38a1

I just replaced a full fuel pump kit in my military fuel pump,
but I have found that the shorter bolt of the two that holds pump on to block is stripped.

I have re tapped the thread in engine which is 5/16 unc, but the bolt
is beyond saving.

does anyone know were I can buy 2 x new ...

good morning all

my gauge reads 260 on temp gauge on my m38a1,
the temp switch I have changed 3 x times its 24 volt electrics,

now what is going on is when I do go out on a private road the gauge goes up to 260 every now and then there is no over heating problem the gauge just goes up, I have cut ...

wilfreeman wrote:Good luck Eddie! I know registration can be a pain here in the US - I know it is probably the same over there too.

THANKS
I WILL KEEP YOU UP DATED.

MY MATE NEEDS THE SAME INFO BUT HIS MD NUMBER IS A LOT HIGHER THAN MINE.

wesk wrote:MD 18088 was manufactured by Willys in Toledo, Ohio, USA September 1952.

wes, i will be back in touch in a few days and let you know how i get on.

thank you.

eddie