willysmjeeps.com

My canvas top is a little too tight for my m38a1. The back bottom corners need to come down about an inch. I was just wondering is there anything I can put on the top to make it stretch.

I know the m38a1 fenders from late 53 to when they stopped making the m38a1 the fenders didn't bolt to the frame. The grill bolted to the crossmember.

Does anyone have pictures of the engine side of original m38a1 fenders. I think mine are aftermarket and this could be why they won't bolt to the frame. If you can send me some to gwkj@aol.com I would appreciate it. Thanks

I have extra electrical connectors both male and female. I am selling them in a set of ten. That will be 5 male and 5 female with the rubber connectors with them. I don't know how to put pictures on here but if you send me your email or number I will send you a picture of them. I am asking 20.00 and ...

Don't know how to put a picture of it on here but will put one on the m38a1 site.

Well worked on it all day. Got my turn signals working and my doors on.

Putting in my heater on my m38a1. Directions say to attach braceto the fender splash shield. I looked and don't see it. Anyone have a picture of it so I can see what it looks like. Thanks

I have the other turn signal kit. Do you have any pictures of the extra light installed on any m38a1s?

I already did that Wes. I put both tail lights the same so I could have brake and running lights on both sides. I bought a turn signal kit but my wires aren't made to take the harness on the turn signal. I was going to try to put in a two filament bulb for the brake and turn signal instead of adding ...

Has anyone ever changed the rear light on driverside so it could take a two filament bulb instead of a one filament bulb?

I will take a picture of the wires under dash with the numbers and pit them on here to see. I will be better to explain with pictures. I do have the switch shown above for the m37 on it.

M38a1 is a stock 24 volt system. I Got the wiring harness from Calvin Ishmael.

It isn't hooked up. Was told it goes to heater switch if one was installed.

Wes I have m38a1 electrical problems. This is going to be a long one. First no juice to light switch at all. I have an ignition switch that has 4 wires coming from it labeled A,B,C and D. A and C are hooked together going to hot wire. D is hooked to 12 and B has 2 wires coming out from it labeled 85 ...

Thanks