willysmjeeps.com

M38A1 is SOLD.
Thanks to all who inquired.
Tom

Still for sale $7500. or best offer.
Thanks For Looking
Tom

Located in IL. ten miles East of St Louis, Mo.
Unable to finish, runs, drives, needs brake work
Converted to 12v with civi ign. by previous owner.
Five new 7:50x16 NDT tires,
Newer Top, NO Doors
Extra Parts, Clear IL. Title, Currently Licensed, and insured.
Will need to load on trailer
$9,500.00 ...

We don't have any Lead smelters here anymore thanks to the EPA.
It has to be sourced from Guess where.
Tom

1st gear is non synchronized.
So when going from 2nd to 1st you have do rev the engine with the clutch
Out and trans. in neutral to a approx. RPM that the engine will be turning
Once you complete the shift and let the clutch out again.

Practice.
Also the faster your going the higher the rev. so ...

Awesome!!!
Tom

The normal oil level is above the rear output shaft,so yes oil
Will run out when you remove the yoke.
That's why your instructed to drain the case before you start.

Simply pry out the seal and install an new one.

They make a tool for prying out seals also.

Tom

Thanks Wes. I really don't care if the radio works. I just want one of looks. I found a NOS one he's asking $400 for it. It's just the receiver/transmitter. I feel like that's high.In my opinion.

If I was wanting one I would think that's fare, You can always pick one up
Anywhere right?

I've paid ...

Thanks for the links Wes.
Tom

I've searched this topic and have found results, unfortunately there a couple years old, trying to get up to date info. From my research, the r15 are newest replacement, but are a bit big on the fit side. In 2013 wesk said 22NF were best. Is there any others, or just those 2 ? Also does anyone use ...

I don't think I ever had to bleed any oil gage.

After you shut it down what little air is left works back to the engine.

Start it and see.
If you must bleed, crack the line at the gage, but I don't think you
Will need too.
Tom

wesk wrote:The drop box is a public file and is also PDF. It opens on line and then you click the top right little box with 3 dots and then click "Download".

Three dot box took me nowhere, but the download link worked after I got pass the pop up for logging in or registering.
Thanks for the help
Tom

You will need the front cap off if you have to remove the rubber insert. It comes out the front. Use the appropriate chapter of TM 9-1825E Bendix component manual. The manual is in our downloads sections in two parts. Chapter 4 for the early light switch and chapter 5 for the connectors.

http ...

Nice Find!!
Pure Gold There.
Tom

Also would add to check charging system for an Over Charge
Condition.
Higher than normal voltage will heat up the coil quickly.
Tom