willysmjeeps.com

Looking to but M38 Seat springs

Wesk
what is the number and size brake cylinder for the rear.
11 x 2 inch shoes

Thanks

4x4m38
Thank you for the information

Anyone know the length of a M38 engine stay cable?
Thanks

Thanks for the information

Is the military junior filter same for both mb gpw and m38 engine.
As I understand the mb has no Oiler fitting inside the timing chain cover and the oil pressure is regulated by a small hole inside the oil filter canister.
The M38 has a Oiler fitting inside the timing cam cover that regulates oil ...

I need the lever that manually operates the wiper located on the vacuum motor as shown in the last picture.
Not looking for complete unit, only the lever.

Looking to buy switch levers for trico vacuum motor

Correct I was looking for steering bellcrank.
My problem is I have NOS M38 bellcrank and I can only find crappy foreign made parts for it. The problem is the 7/8 x 1 1/4 spacer is too short in length
This causes the bellcrank to bind up unless I machine some material from the new bellcrank. Also I ...

Looking to buy NOS M38 steering bell crank and rebuild kits.

Walcks has new reproduction cj2a springs.
Brent Mullen has NOS springs and pans, bottom only.brent also has the padding.

May be possible to use some m151 wiper motor parts.

Looks like I will be buying a repo M38 rear seat frame.
Any info on who has the best ones available, the good bad and the ugly.
Thanks

I am looking for a original rear seat frame and not having much luck. Looks like will have to get an aftermarket one.
Any comments pro or con pertaining to an after market seat frame?
Thanks

Keep in mind that your gas gauge is actually a voltmeter. When 24 volts are applied to a stock 24 volt gauge the meter will read full.

As the fuel level lowers the sender increases resistance, the voltage is decreased causing the gauge reading to drop.

You will not be able to make the stock 24 ...