willysmjeeps.com

Nothing much more to say. I need an M38 crank. Preferably already turned but one I can turn. Gear driven cam block.
I am located in Houston, TX,

Trip

And to you and everyone else as well

Charles Lantrip

As always, thank you Wes.

Trip

Does anyone have a photo or two showing the correct orientation of the 2 frame mounted brake line clips holding the brake line in place to the frame?
These 2 clips are between the master cylinder and the rear frame cross member.

Thanks in advance.

Trip.

what is the best way to clear a brake line that is obstructed ? I have tried solvent, air and everything else I can think of.

I thought someone on here might have a method I have not tried.

Brake line is oem and in good outside condition and I would prefer to save and re use if possible. It is ...

Thanks Wes,

I will try that as it seems like it would work.

Trip

Thanks to all for the help. I had gasket material and made a copy from that.

However during the take down of the steering gear box and inspection, I did notice the original gasket was very thin similar to a manila file folder..

I did not understand the "Ball Peen Hammer" reply.

Again, thanks for ...

Anyone have a source for the above party?

I have been told to make it out of a file folder, but that is not my preferred method.

Evidently this gasket for the m38 is bigger.

Thank you,

trip

I am in need of one Willys rim for one of my M38 jeeps. (16x4.5) Military

I am in Houston, TX. so the closer the better. I can pickup within 200 miles or so.

Trip

I recently visited and purchased an M38 original take off gas tank from Brent Mullins in College Station Texas. I was allowed to choose my tank from a dozen tanks. The tank was somewhat rusty inside but cleaned up perfect. Being original it had the correct brackets and wire/tube clamps still ...

Dennis,

Welcome to the site. Please post photos of your progress.

Trip

Wes,

Your depth of knowledge and your ability to answer (so quickly) and guide us newbies never ceases to amaze me.

Thank you and the others for all you do.

Trip

Brian,

I have sent you a pm.

Trip

My description of the part needed may have fallen short. I need the tool box cover that is spot welded to the floor pan. The hinged lid is spot welded to the cover. The cover also contains a scripted "JEEP" on the front.

Thank you for your reply.

Trip

I am looking for an M 38 Tool Box Cover. New or used but in very good condition.

Thanks in advance,

Trip