Spacers for gas can holder
What are the dimensions for the Gas can bracket/holder spacers? I would like to make me some. Also what diameter is the bolt that is used to hold it on with?
Search found 5 matches
- Wed May 21, 2025 5:02 am
- Forum: Technical Knowledge Base
- Topic: Gas can bracket/holder spacers
- Replies: 2
- Views: 650
- Wed Apr 10, 2024 1:03 pm
- Forum: Technical Knowledge Base
- Topic: flywheel advice
- Replies: 2
- Views: 1444
flywheel advice
When I removed the flywheel (129 tooth model) from my engine I did not mark it's position on the crankshaft. Will I encounter a problem when I put it back on if it is not put back in the exact spot?
- Mon Apr 01, 2024 3:28 pm
- Forum: Technical Knowledge Base
- Topic: conversion from a 12 volt system back to a 24 volt system
- Replies: 7
- Views: 3328
conversion from a 12 volt system back to a 24 volt system
Has anyone done a conversion from a 12 volt system back to a 24 volt system? I would be interested in the cost and any eventual problems encountered. It looks like everything from the distributor, generator, starter and VR to the wiring harness would need to be replaced. If one follows the TMs and ...
- Mon Oct 23, 2023 5:50 am
- Forum: Wanted
- Topic: Willy's Engine Block
- Replies: 1
- Views: 2289
Willy's Engine Block
I need a 1952 F Head Block. Can anybody help me out?
- Mon Oct 23, 2023 5:42 am
- Forum: Technical Knowledge Base
- Topic: Anyone tried this before
- Replies: 3
- Views: 2249
Anyone tried this before
I just helped a buddy install a CJ3B crankshaft, just because he was told that the CJ3B crankshaft would make his jeep run smoother and faster. He went all out and rectified a old 3B shaft and installed all-new matching bearings.
He has a M38 with the F-engine, soooooooo...
Opinions, anyone?
He has a M38 with the F-engine, soooooooo...
Opinions, anyone?