Torque specs

haj81 · Post by **haj81** » Sat Aug 08, 2009 8:20 pm

what is the torque spec, and sequence on a L134?

Post by **wesk** » Sat Aug 08, 2009 9:25 pm

Are you using studs or bolts?

haj81 · Post by **haj81** » Sat Aug 08, 2009 10:13 pm

I'm using studs on this flathead, it's a 46 CJ2a

Post by **wesk** » Sat Aug 08, 2009 10:53 pm

The civvy service manual SM 1002 calls for 60-70 Ft Pounds but I think that may be a tad high for fine threaded nuts used with the studs. I would torque to the lower end of the posted torque.

haj81 · Post by **haj81** » Sun Aug 09, 2009 7:59 am

Wesk; Thank you for this info, now I have something to do today. I just acquired this project a few days ago, and it's nice to know there is an informed group that is generous enough to help me get through it. I'm off to the shop for now. Thanks again.
Jay