engine troubles

Discussion topics on Willys Overland M series vehicles
Post Reply
User avatar
lake
Member
Posts: 32
Joined: Sun Aug 23, 2009 6:00 pm
Location: Nova Scotia ,Canada

engine troubles

Post by lake »

I seem to be puzzled my 1953 m38a1 runs great for the first 10 mins . of driving ,then starts to miss real bad and run real rough as if it is not getting any gas. I think it may be getting hot ?. When it stops it will not start again for several hours. I put new plugs and gas filter on it and checked the wiring . It has me really puzzled, I need some good advise .Lake.
User avatar
wesk
Site Administrator
Site Administrator
Posts: 16469
Joined: Sun Apr 03, 2005 6:00 pm
Location: Wisconsin
Contact:

Post by wesk »

Classic symptom of a plugged gas tank vent. A quick and easy test is to remove the gas cap and drive the jeep. If the problem is gone then unplug the tank venting system. There are two lines on top of the tank. one is a vent. Find the end of this line on early A1's and wiith the gas cap OFF blow through the vent and make sure you can here air moving in the tank. If you have a later M38A1 without the fording vent line plumbing there will be a vent cap on top of the tank. Remove it and make sure air can flow into the tank. Also check your gas cap. There are two types, vented and selectable vented. The selectable vented has a center plate inside that has two positions: "CLOSED" for fording and "OPEN" for normal use. Make sure it is open.

Image
Early A1 with vent line plumbing.

Image
Late A1 with vented fitting.

Image
Selectable type cap.

As you have probably surmised for the symptoms you have it means that both the on the tank vent and the cap must be plugged to cause your symptoms.
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
User avatar
lake
Member
Posts: 32
Joined: Sun Aug 23, 2009 6:00 pm
Location: Nova Scotia ,Canada

engine trouble

Post by lake »

O.K Wes I will give fenting a try before maybe looing at the carb,thanks Lake
Post Reply