PTO cover plate

[evanso1975]

Hello All,

One of the PO's remanufactured the front floor and transmission tunnel in my M38, but neglected to put the PTO hole and cover plate in it. Does anyone have photos or sketches showing the following:

a) Size of the PTO cut-out
b) Size of the PTO cover plate
c) Positions for the above items, from a suitable reference point (say, the edge of the toolbox, and the face of the rear floor riser panel)

Thanks in advance,
Owen.

[RICKG]

I CAN HELP YOU WITH THAT-I'LL GET A PHOTO AND SOME
DIMENSIONS AND GET BACK WITH YOU TOMORROW.


1. THE PTO CUTOUT IS 2-5/8" SQUARE.
2. THE PTO COVER PLATE IS 3-5/16 SQUARE.
3. THE CUTOUT IS POSITIONED 1" FROM THE EDGE
OT THE TOOLBOX AND 15-3/8" FROM THE EDGE OF
THE REAR FLOOR RISER. HOPE THIS HELPS.

[evanso1975]

Hello Rick,

That's exactly what I was looking for. Many thanks!